Finally the two servants were installed and configured the remote control properly with the help of telephone MaxCipollino Forum RC-Monsters. Initially I was not able to obtain the desired result for the 4 wheel steering because I could not configure the switches properly, then Max, from his experience, he politely pointed out the error incurred in: a switch can not be associated reversal of a channel.
This configuration of the channels on the RX:
- Channel 1: accelerator
- Channel 2: Channel 5
- steering front: rear wheels
The switches are configured independently of each other, but in mirror image : what makes one, the other does the reverse, but both are connected to the rear servo. Specifically, the switch activates the right front axle at the front as opposed increasing the capacity of the vehicle steering, switch, front left, instead, turn on the front and rear axle favoring them carried the half crab style.
While the first configuration can be useful steps to deal with eliminating some maneuvering tight corners, the second can be useful in those occasions when, to overcome the obstacle, the only axis with respect to the obstacle to change is the latitudinal ( when it is almost aligned along the length but the width decentralized, and is useful in races Trial).
I trim the transmitter are digital, and this eliminates any possible loss of calibration during the transport.
Personally I have not set the function FailSafe, RC and RX that support it, because it is difficult not to reach a crawler out of reach. The initial configuration chosen as the radio is on the plane instead of the helicopter.
I just have to wait until Sunday when I should try with all the other friends of RC-Monster bell'angolino somewhere in the hills of Florence, hoping that the choice of the stick instead of the wheel I do not discriminate too much.
Good evening.
 |
| 4 Steering Wheels |
0 comments:
Post a Comment