How To Get The P90x For Free

Places: Roveta quarry and woodland

Near Scandicci, near Florence, is a place where you can practice a bit 'of everything in dell'automodellismo RC: the bush. Virtually
the place where they can challenge themselves with almost perfect Rock Crawling, Off Road, Fords and jumps.
A few kilometers from Scandicci, it is easy to reach after a few bends in the beautiful green of Tuscany, and then reach a pitch where can fit 5-6 cars. From here, following a small dirt road, we arrive at the quarry, continuing, after about 150 meters on the left there is a path: ahead will arrive in a couple of minutes to the grove.
For photos of the grove, I refer you to this post , while photos can be found at the bottom of the pit, usually in the Picasa album.
now analyze the site.

Cava: composed primarily of earth and gravel resulting from the disintegration of the stones. In part that "sale" you can try go up when the tire grip is the master, while the bottom one can fun with a little 'of Rock Crawling. Part
steep and composed of very fine earth and stone fragments small enough, or small just enough to prevent the means of attack to go on: a tire that is very clawed best suited to this section.
The downstream part of the cliff, however, is strewn with rocks on which, however, the grip is made difficult by dust and dirt deposited: If you want to build a path to something serious, the advice is to literally clean up the track . However, the Media 2.2 "are more difficult because of the size of the tires.
The flat part, though littered with stones of medium size, allows it to fun means faster, maybe even a petrol-type trucks and truggy. For the buggy not recommended because the tires are not likely to soften the harshness enough. On the right side of the flat part, are also a few bumps to be able to take advantage of spectacular jumps, since the spaces allow rapid acceleration and landing respectable.

Grove: For the grove it is very different, and the type of place, whether the composition of the soil.
Overall, the area does not have spaces that you can use these high speed vessels and is therefore preferred by crawlers and scalers. But the shape of the place and the composition of the soil, will make all especially fun for the latter, the scalers, who will find a beautiful place to tackle steep climbs and descents, river crossings, gradients, and mudflats.
The shadow is that, in the grove, that in case of rain, the place takes a long time before it starts to dry and this will bode fun trip in case of post-shower.
The soil is compact, where dry, but very slippery where wet. Along the stream of water, are easily found mud pools, great fun for your Mud Slingers.
It is very easy to create routes, more or less articulated, more or less long.
areas are not too deep to ford and in the case of my CR-01, hardly can cover the front axle. Tamiya cars like the F350, however, may have trouble due to the arrangement of the battery pack, close enough to the ground.

Tires: As you have understood, hard to tell what kind of tire is suitable for this place, given the variety of "disciplines" that can be applied. Off Road in a rubber soft compound could well adapt to both areas, but if you want to do things right, bring two trains: Soft Rock mix, mixes media from Off

ESC: Same goes for the configuration ESC: or find a middle ground (in medio stat virtus), or reconfigured as needed. If you lean towards the middle, have a look at the setting of the brake to avoid sudden braking on slippery rocks of the quarry. The autobrake, however, should keep it to 80% so that the vehicle can travel alone if the steep descent slowly. Reverse 40% linear and GAS, to the detriment of the exponential which can cause many problems on slippery surfaces.

I leave you, as always, the links to find the place and the Picasa photo album.

Hello everyone.

Google Earth Google Maps

Places: Roveta

Best Surround Recivers

Late post

Lately some sho 'of little things to do, but this takes time to crawling and walks in the woods with other boys of RC-Monster.
I have several pictures to post with a description of the place: the Roveta Scandicci, Scandicci above a lake, Monte Morello.
I'm also starting a series of changes to CR-01, with the aid of the boys always practical design of RC-Monster.
The changes at the moment, involving the suspension and the pressure of the medium. For suspension I would like to eliminate the system of levers to install dampers standard having lifted torsion bars, the medium has gained twist, but at the same time has become a little 'funny' in meaning that in motion tends to dance a little bit because of the game read the levers. By coupling a fixed standard ammo that should disappear and the hike increase. I also ordered bedlock
wheels and tires, all ProLine: the wheels are aluminum and should increase the weight of the vehicle moving, then the center of gravity down, the tires always ProLine Badlands are a medium compound with memory and inserts because of their structure, should provide a greater grip on backgrounds with soil and mud.
Soon you will have the pictures of the bush, the modified medium with ammo, just follow the evidence reach the tires of the same.
soon will have a free moment Wrighi, should start heavier frame with the replacement of some plastic parts with their built in aluminum.
What, are so many ideas and suggestions as well: now I just have to find time to do them.

Cell Phone Voice Mail Funny Greeating

Places: Campi Bisenzio a

Near Campi Bisenzio, Florence, 100 meters from the ring, is also a place in which to entertain. It is not very wide, and does not allow the use of high speed vessels to its conformation, but provides entertainment for those who want to do some 'of crawling on the ground.

Land: The land consists of an accumulation of dried mud, moved by a bulldozer which created a small "mountain" at the bottom of the pitch. The sides are slippery as tends to crumble, but in some places the grip is high enough to permit a ladder to reach the summit. From here you can walk around the ridge to reach the other side of the pitch. E 'can also get off on the other side, although the space is tighter than the front.
the base does not change the soil composition, but the big wheels of the excavator have created small areas beaten and sunk.
It is very easy to create a route with flags or markers.
On the right side of the pitch also was dumped debris made up of rocks and slabs of raw concrete, height about 2.5 meters. Difficult to climb to the summit, but it's still funny try it (personally I did not succeed).

Tires: Tires from pure Rock-Crawling, needless to say that we do not find a better place to express their full potential. My advice is to rely on a more off-road rubber, with teeth enough distance between them. If the teeth are rectangular, it is better latitude than the shoulder to get more grip.

ESC: ESC To recommend only change the AUTO-BRAKE entry to a value not too high, leaving the lever to prevent the wheels tend to stop abruptly sliding the middle. A value of 30% should ensure a soft initial energy that can Then you manually highlight. For the MAX-BRAKE, instead, a value between 70% and 100%.


I just have to leave the links on GoogleMaps and GoogleEarth, perhaps with the wish to meet, and link to Picasa gallery to have an idea of \u200b\u200bwhat the site offers.

GoogleEarth GoogleMaps

Places: Campi Bisenzio 1

Brasilian Mooms Picturs

Meetings: June 8, 2008, Roveta

On 8/6/2008, near Florence, I found myself with Friends of RC-Monster.it in the bush. A very nice place to do some 'Rock-Crawling in the quarry and maybe going into some ford little further along the path.

An analysis of the place you have to wait a few days: the time to write it.

Links:

• STECCO, DIY half from Stephen, great thanks to the generous sized crawler tractors and its height.
• GINGER, half from DIY Tittosmodel, the yellow truck 6x6, a gem that is second to none and land, only weak point: the long wheelbase.
• Truck 6x6 gray, half from DIY Wrighi, a scientist from the model along with Stephen Titto. The sound that emits the truck to deliver power per motor revolution.
• CR-01, half-built box PIF (I), whereas excellent potential that has not changed at the time of the meeting: he left everyone amazed at his talents.

Unfortunately the missing half of @ @ Maxcipollino who broke an arm after 10 minutes, leaving no time for a shot. I assure you that his Monster, suitably modified for Trial races, is second to none in category: fast, a couple incredible, and tires ready to dig the ground over which they flow.

Here is the album of the meeting:

Roveta

And here's also two videos: Video 1 and Video 2 .

Mostfungames Kostenlos

Changes: Increased TWIST

To improve the behavior of Cr-01, you can take different roads that touch on the various component parts. What I want to improve today, thanks to the suggestion of a friend, is the angle of TWIST, the ability of the model to keep the wheel on the axis corresponding to the ground opposed lifting the other.

Example: With the model "parked" raise your left front wheel to the point where the left rear wheel is raised off the ground. At a time when the rear wheel lifts off, you've reached the maximum twist.

The CR-01, according to the Tamiya designers, equipped with a system that should improve its footprint ground, providing a good grip on the part of the 4 tires. The Tamiya mount a leverage system, with separate spring and shock absorber, the spring return is guaranteed by a system of levers which the shock is anchored. Within this system of levers, installed the torsion bar connecting the levers which the bridge is given: the front is more Mobido on the back harder.

This bar, however, decreases as the twist while making the system more robust, the other by force of circumstances preventing it stiffens the maximum load, the longitudinal excursions, on the opposite wheel.

delete, widen the travel of spring softening opposite the bridge, which can then load up one or more shock more freely.

Following are the photos that show the piece to be deleted, and the coupling once removed the bar.

Mouthwash Good Or Bad

Welcome, Introduction

Hi, I'd like to tackle in this blog is an argument that in Italy comnciando to catch on, albeit very slowly: The Rock-Crawling RC.
And I left my half a Tamiya CR-01 providing impressions and changes to be made fun in places where the Florentine area and land.

For the section Photo probably I will entrust to Picasa Webalbum, while I hope to secure the cooperation of friends in the drafting of the articles.

I will try to divide the sections in a clear and easily available, we will have a section of sites with soil analysis and any recommendations and the behavior of CR-01, we will change with the parameter definition section of the advantages and disadvantages, accessories and options, all reports of possible matches. For places, inevitably, I will use Google Earth.

For the moment you place a greeting and a warm welcome to my "Cyber-Space."